RMA Request – Welcome to Fox

RMA-ANFRAGE

FOX SUPPORT

UNTERSTÜTZUNGSPROZESS

HABEN SIE DEN PROZESS BEFOLGT?

Step 1
Step 2
Step 3
Step 4

Use Resources
Please refer to the product user manual and our online technical support resources, including our knowledge base, in the first instance. Many issues are easily identified and resolved using these tools. Please attempt to use these tools before proceeding to step two.
Contact Support
If you are unable to resolve the issue using our support documentation, please get in touch with the Fox team. Calling from the site where the product is installed can often result in a quick resolution and/or identify immediately if the unit is faulty, so please do this where possible.
Support Ticket
Once you have contacted Fox support, and if the issue cannot be resolved following any guidance issued, a support ticket will be created and you will be given a support reference. Please note down this reference as it will be required for any subsequent RMA request.
Warranty Claim
Only when you have followed the previous steps, and when advised to by Fox Support, should you proceed to apply for a replacement. This would usually happen only once a Fox technician has confirmed that a replacement is required. Please complete form below.

SCHRITT 4 - GARANTIEANTRAG EINREICHEN

Bitte geben Sie so viele Informationen wie möglich an und stellen Sie sicher, dass alle erforderlichen Felder ausgefüllt sind.

Page 1 of 6

PRODUKT-DETAILS

Vorkontrollen*

Bestätigen

Bitte bestätigen Sie, dass die erste Fehlersuche von einem entsprechend qualifizierten Solarinstallateur durchgeführt wurde und dass die Online-Ressourcen und/oder das Fox-Benutzerhandbuch zur Anleitung herangezogen wurden. Unterstützung erhalten Sie vom Fox-Support-Team mit Hilfe von Online-Tools und in bestimmten Ländern auch telefonisch.

Bitte akzeptieren Sie unsere Bedingungen*

Please select to confirm that you understand the FoxESS warranty process and that you agree to the terms and conditions. Country/territory specific warranty policies are listed at the foot of this page.

Akzeptieren

Datum der Anfrage*

Should be today's date.

Datum der ursprünglichen Installation*

Land*

Seriennummer des Produkts*

The serial number can be found on the label attached to the side of the product.

Produktmodell*

Bitte wählen Sie das Produktmodell aus. Wenn Sie sich nicht sicher sind, lassen Sie das Feld leer, da wir das Modell anhand der angegebenen Seriennummer identifizieren können.

Warranty Registration

Has the product warranty been registered?*

FoxESS offer an online warranty registration facility. This is not essential, however it is recommended and is required for those wishing to benefit from the FoxPlus warranty.

Yes

Don't Know

If yes, please specify certificate number (if known):

This is not compulsory, however it may help to speed up the replacement process if these details can be provided.

Please specify the support ticket number issued to you by FoxESS.

Before filing an RMA request, you need first ensure you have used the FoxESS help resources and have logged a support call with FoxESS, who will have provided you with a support ticket number. Please enter the reference here.

Notes

If you have spoken to FoxESS support, but you were not provided with or have lost this reference, please provide details (e.g. the name of the FoxESS representative you spoke to).

Claimant (Installer) Details

RMA requests should only be made by a suitably qualified installer. Please enter your details here. End-user contact and address details are entered on the next page. The installer can be the original installer of the product or any qualified installer sourced by the end-user to oversee the replacement of the product.

Business Name*

Name of the installation company making the claim.

Contact Name

Primary contact at the installation company.

First

Last

Preferred method(s) of contact

Mobile

Landline

Mobile Tel.

Landline Tel.

Email address

Installer Address

Building No./Name*

Address 1*

Address 2

Town/City*

Region/Province

Postal/ZIP Code*

End User Details

Please enter end user details here. Please note, all contact will be with the claimant (installer) only except in exceptional circumstances. The end-user details are for our records only and are not shared with any third-party. As the claimant will be acting on behalf of the end user, please obtain permission of the end user before sharing their details.

Customer Name

Name of the end-user.

First

Last

Preferred method(s) of contact. Please note, we will not contact the end user directly, however these details may be required should you opt to ship the replacement unit direct to the end user address:

Mobile

Landline

Mobile Tel.

Landline Tel.

Email address*

End-User Address

House No./Name*

Address 1*

Address 2

Town/City*

Region/Province

Postal/ZIP Code*

End-User Permission

Please select to confirm that you have obtained permission from the end-user to share their details.

Yes

Fault Details

Fault Type

Intermittent

Permanent

Message On Screen/App

If there is an error code/status displayed on the inverter screen, or in the log recorded on the remote monitoring platform, please enter here.

If there is an error message displayed on the inverter LCD screen or on the monitoring portal, please specify here.

AC Check*

Yes

N/A (off-grid)

Have you measured AC voltage at the plug, or recorded it from the inverter status screen, to confirm there has been no loss of mains power, either because of a loss of grid power or because of wiring issues between the incoming mains supply and the inverter?

DC Check*

Yes

N/A (AC charger)

Have you checked to ensure that there is DC voltage at the plug, or recorded it from the inverter status screen, and have you confirmed that the incoming DC voltage for each MPPT is within the voltage parameters of the inverter?

Recorded AC Voltage

AC voltage recorded manually at the plug, or read from the inverter status screen/remote monitoring platform.

Recorded DC Voltage - MPPT 1

DC voltage for MPPT1 recorded manually at the plug, or read from the inverter status screen/remote monitoring platform.

Recorded DC Voltage - MPPT 2

DC voltage for MPPT2 recorded manually at the plug, or read from the inverter status screen/remote monitoring platform.

Install Environment Check*

Yes

Have you checked the install environment to ensure that the inverter has been installed in accordance with the installation guidelines, that the inverter is not installed in a corrosive environment and that there is sufficient clearance around the inverter as per the guidelines outlined in the installation manual?

Physical Location *

Which of the following best describes the location of the inverter?

Indoors

Outdoors - Some Shelter

Outdoors - No Shelter

Fault Description*

Please provide a full description of the fault and provide details of any checks or actions taken to rectify the fault.

Supporting Information

Please provide any information to support this request, including any relevant photographs of the product or screenshots from the monitoring platform.

Upload

Maximum of 8 files. Maximum file size for each attachment is 10MB. Allowed formats: jpg, jpeg, png, gif, pdf. Please ensure you provide any documentation that has been requested by FoxESS support in response to your support ticket, or alternatively, refer to the knowledgebase for guidance on the types of documents you should upload here.

Address Preference

Replacement Address*

Subject to the acceptance of this request, a replacement unit will be sent to your preferred address, either the installer address or end-user address entered earlier on this form, please specify.

Claimant (Installer Address)

End User Address

This field should be left blank

WICHTIGER HINWEIS

Bevor Sie Ihre Anfrage abschicken, vergewissern Sie sich bitte, dass Sie die Fox-Wissensdatenbank und alle von Fox zur Verfügung gestellten technischen Support-Ressourcen konsultiert haben (bitte beachten Sie das auf dieser Seite beschriebene Support-Verfahren).

HINWEIS FÜR ENDNUTZER

Dieses Formular sollte in jedem Fall von Ihrem Installateur ausgefüllt werden. Sollten Sie nicht mehr in der Lage sein, Ihre ursprüngliche Installationsfirma zu kontaktieren, empfehlen wir Ihnen, sich an einen entsprechend qualifizierten lokalen Installateur zu wenden, der eventuelle Probleme untersuchen kann, bevor Sie eine RMA-Anforderung einreichen. Um diesen Antrag zu bearbeiten, werden Informationen benötigt, die einen ersten Besuch vor Ort erfordern.

ANNAHME

Nachdem Sie einen Garantieantrag mit den entsprechenden Unterlagen eingereicht haben, erhalten Sie eine Antwort per E-Mail mit einer RMA-Nummer.

Fox behält sich das Recht vor, RMA-Anträge abzulehnen:

wenn Fox nicht davon überzeugt ist, dass der Defekt auf einen Verarbeitungs- oder Materialfehler zurückzuführen ist;
wenn das Produkt ohne die vorherige Zustimmung von Fox ausgetauscht wird.